HANGING INSTRUCTIONS
Please read and follow these hanging instructions. Do
not exceed the maximum load limit of 420 lb.
Do not let small children play in the chair unattended. Thank you!
LOCATION: You will need
to satisfy two considerations: First, a
sturdy anchor point overhead about 4-ft. wide, (for the two screw hooks).
Nothing less than 2” x 6” framing lumber should be used. Second, you will need space below for the
chair to occupy. Roughly the same size
that a love-seat or similar piece of furniture would require: An area of approximately 5-feet by 6-feet.
INSTALLATION OF THE HOOKS: Using a 5/16” bit, drill two pilot holes into
the center of the framing members. Drill
straight-up (plumb), about 2” deep.
Install the hooks; be sure to bury all the threads.
HANG AND ADJUST THE CHAIR: Hang the chair from the hooks
and slide the adjusting blocks down the support ropes until the chair is level,
the correct height from the floor, and reclined to suit your needs. Toss the cushions in and have a
seat. Make further adjustments as
necessary for height and angle of recline.
CARE & MAINTENANCE: Spot clean the pillows. Clean the ropes using warm, soapy water and a
soft bristled scrub brush. Rinse thoroughly
and allow to dry completely, preferably in direct sunlight. To spruce up the wood frame, carefully apply
furniture oil using a soft, clean cloth.
DO NOT store your chair where
mice or bugs may be present.
COBBLE MOUNTAIN,
INC.
PO Box
800-322-5232 or 802-439-5232
Email: info@cobblemountain.com Fax:
802-439-5234